ada-mode: Moving Through Ada Code
7 Moving Through Ada Code
*************************
There are several easy to use commands to navigate through Ada code.
All these functions are available through the Ada menu, and you can also
use the following key bindings or the command names. Some of these menu
entries are available only if the GNAT compiler is used, since the
implementation relies on the GNAT cross-referencing information.
‘M-C-e’
Move to the next function/procedure/task, which ever comes next
(‘ada-next-procedure’).
‘M-C-a’
Move to previous function/procedure/task
(‘ada-previous-procedure’).
‘M-x ada-next-package’
Move to next package.
‘M-x ada-previous-package’
Move to previous package.
‘C-c C-a’
Move to matching start of ‘end’ (‘ada-move-to-start’). If point is
at the end of a subprogram, this command jumps to the corresponding
‘begin’ if the user option ‘ada-move-to-declaration’ is ‘nil’
(default), otherwise it jumps to the subprogram declaration.
‘C-c C-e’
Move point to end of current block (‘ada-move-to-end’).
‘C-c o’
Switch between corresponding spec and body file
(‘ff-find-other-file’). If point is in a subprogram, position
point on the corresponding declaration or body in the other file.
‘C-c c-d’
Move from any reference to its declaration, for from a declaration
to its body (for procedures, tasks, private and incomplete types).
‘C-c C-r’
Runs the ‘gnatfind’ command to search for all references to the
identifier surrounding point (‘ada-find-references’). Use ‘C-x `’
(‘next-error’) to visit each reference (as for compilation errors).
If the ‘ada-xref-create-ali’ variable is non-‘nil’, Emacs will try to
run GNAT for you whenever cross-reference information is needed, and is
older than the current source file.
Info Catalog
ada-mode: Compiling Examples
ada-mode: Top
ada-mode: Identifier completion